Maytag Washer Door Lock Blinking. Either the f8e1 or the lf error codes may indicate there is some problem with the water supply going to the washer. To unlock the controls, press and hold the cycle end signal for 3 deliberate seconds or until the control lock light goes out.
Troubleshooting Maytag Washer That Won’t Spin DIY from howtofixit.net
This washer has sensors that detect the water supply and requires both hoses to have water going to the water valve. The door should unlock after 60 seconds. If the sensor light on your maytag washer is continuously flashing, this is usually caused by an obstruction preventing the washer’s tub from engaging with the engine.
One Of The Ways You Can Reset Your Maytag Washer Is By Rotating The Main Dial In A Specific Order.
The washer will go into a hold and drain routine for 8 minutes. If the control locked light will not turn off, i recommend unplugging the washer for 5 minutes. Be sure the washer is in standby mode (plugged in with all indicators off).
The Door May Be Opened.
It could also mean that power has been interrupted. Either the f8e1 or the lf error codes may indicate there is some problem with the water supply going to the washer. In their troubleshooting section of the website, the maytag company suggests that issues with a blinking lock light may be caused by issues with the actual lock itself.
Try Unplugging It For At Least 5 Minutes.
Hold down the play/pause button for 5 seconds. Please make sure both inlet hoses are connected and both hot and cold water supplies are turned on. Located on the bottom of the door switch/ gently pull the tab down about a 1/4˝ or.
Nothing Else Will Appear To Be Happening With The Machine During This Time.
Step 4 shut the washer's lid or door to securely close. This is all it will do. You can try resetting the machine to release the lock or explore several mechanical components that can be the cause.
And Removing The Bottom Front Service Panel As Shown In The First Image Below.
This device controls part of the transmission process of a washing machine engine. After reset, sequence “1” through “5” must be completed within 6 seconds. Click to see full answer.
